Berner Truck Pac Bedienungsanleitung Seite 68

being jump started with the Truck PAC unit likely contain liquid acids which are
hazardous if spilled.
OPERATING INSTRUCTIONS
Never hook up a 12 Volt DC power source to a 24 Volt DC vehicle. This will grossly
overcharge the 12 Volt power source and generate flammable gasses that may explode
and cause property damage and/or bodily harm.
Safety Check List
Always Perform this Step Before Use to Ensure Safe Operation
1. Check that the 2 vent plugs in the rear case are in good condition, are fully
seated and the white GORE-TEX
WARNING
WARNING: if the plugs are out of position or the white material is missing
Failure to follow instructions may
or loose, this means that the venting system has been activated and the
cause damage or explosion,
batteries are damaged. IMMEDIATELY take the unit out of service, and
always shield eyes. Read entire
send it to an authorized service center.
instruction manual before use.
2. Check to make sure that the Voltage Selector Switch is in the OFF position.
3. Check to make sure that the clamps and cables are in good working
order. Signs that the clamps may be damaged include, but are not limited to
the following:
- Burn Marks on the Jaws
- Damaged clamp handles
- Damaged clamp springs
- Damaged cables where copper wiring may be exposed (insulation jacket
deteriorated, cut or missing)
4. Check to make sure the case is not swollen (a sign of damaged batteries).
5. Check to make sure the holsters (where the clamps should be stored) are in
good condition. These are designed to ensure that the clamps cannot come in
contact with each other, or come in contact with a common conductor.
Verifying these 5 simple check points before every use will keep your jump starter safe
to use and increase its service life.
Used as an Emergency Jump Starter
Note: For optimum performance, do not store your jump starter below 10˚C (50˚F)
when using as a jump starter. Never charge or jump start a frozen battery.
Advanced Warning System (AWS)
Your jump starter is equipped with our AWS – Advanced Warning System – designed
to provide an advanced alert to common jump starting mistakes. Your jump starter
contains a buzzer which will sound an audible alarm if the Advanced Warning System
detects specific undesirable conditions during the jump starting process.
If the AWS Detection Alarm sounds at any time during the jump starting process,
disconnect the jump starter from the vehicle immediately! Always remember to
practice jump starting safety and disconnect the ground clamp first.
WARNING
®
material has not previously been dislodged.
– HAZARD WARNING FEATURE
TM
67