Caso PRO3500 Bedienungsanleitung Seite 17

Cleaning and maintenance
•
Pull the power plug prior to cleaning the device. Do not use any caustic cleaning agents and
make sure that no water penetrates the device.
•
To protect yourself from electric shock, never immerse the device, its cables and the plug in
water or other liquids.
•
Wipe off the ceramic field with a damp cloth or use a mild, non-abrasive soap solution.
•
Wipe off the casing and the operating panel with a soft cloth or a mild detergent.
•
Do not use any petrol products to not damage the plastic parts and the casing/operating
panel.
•
Do not use any flammable, acidy or alkaline materials or substances near the device, as this
may reduce the service life of the device and lead to deflagration when the device is turned
on.
•
Make sure that the bottom of the cookware does not scrape across the surface of the ceramic
field, although a scratched surface does not impair the use of the device.
•
Make sure that the device was properly cleaned before storing it in a dry place.
Problem and Solution
Error Code
E01
E02
E03
E05
E06
E07
E08
Cause
Supply voltage too low
(< 160 V)
Supply voltage too high
(> 270 V)
Possible short circuit
Overheat protection (in
power mode)
Temperature sensor
defective
Overheat protection (in
temperature mode)
Temperature sensor
malfunction
17
Solution
Ensure that the supply voltage
matches the voltage shown on
the type plate of the device.
Ensure that the supply voltage
matches the voltage shown on
the type plate of the device.
Please send the device to
customer service.
Remove the cookware and
allow the device to cool down.
Then turn the device off and on
again.
Please send the device to
customer service.
Remove the cookware and
allow the device to cool down.
Then turn the device off and on
again.
Please send the device to
customer service.