General Directions For Use; Main Components - Zibro R 26 T Gebrauchsanweisung

GENERAL DIRECTIONS FOR USE

Below you will find the main steps to be taken for
using your heater. For more details, please refer to
the MANUAL (pages 41 ff.).
1
Remove all packaging materials (refer to Section A, Fig. A).
2
Fill the removable tank ¾ and wait 30 minutes before you
ignite the heater (refer to Section B, Fig. H).
3
Insert the batteries into the battery holder ¹
(refer to Section A, Fig. F).
4
Check whether the combustion chamber ¿ is fully upright
(refer to Section A, Fig. E).
5
Ignite the heater by turning the knurled wick adjustment
knob · as far to the right as possible and then gently push the
ignition button » (refer to Section C, Fig. K and L).
6
After igniting the heater it will take 10 to 15 minutes before
you can check if the heater burns well (refer to Section D).
7
Switch off the heater (refer to Section E).
As a fire precaution, the tank must be filled either
when the heater has been switched off or in
another room than the room where the heater is
installed.
Always ensure that the tank is closed properly after
filling it at a safe distance from all sources of heat
and open flames (see chapter B).
Store all fuel containers with their original caps
and seals in a cool and dark place.
Fuel ages. Use new fuel at the start of every hea-
ting season.
The use of Zibro Extra, Zibro Kristal or Zibro Bio as
a heating fuel assures you that you have a good
quality fuel.
Before changing brands and/or types of fuel make
sure that the mobile heater first completely emp-
ties all of the remaining fuel inside the heater.

MAIN COMPONENTS

Safety button
³
Knurled wick
·
adjustment knob
Ignition button
»
Combustion
chamber
Combustion
´
chamber handle
Fuel indicator
²
Grill
¶
Lid for removable
º
tank
Removable tank
¾
Removable tank
µ
fuel gauge
Ignition coil
¸
Battery holder
¹
4
39