Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.2 Sight adjustment
Switch on the red dot by turning the on/off-rotary switch and
set its brightness to a degree ideally suited for you. Remove
the protective caps on the windage and elevation screws. In
order to adjust the point of impact of the gun, the appropriate
screw is to be turned into the desired direction. Each click of
the adjustment screws changes the point of impact by 1/3
MOA—.93 mm on 10 m or 9.3 mm on 100 m (.150 in. on
50 yards).
(MOA stands for minute of angle, 1 MOA covers 1 inch at
100 yards)
Elevation adjustment
point of impact too high
point of impact too low
Windage adjustment
point of impact too far right turn windage adjustment screw clockwise
point of impact too far left
4. Care and maintenance
Protect your sight from any mechanical damage caused by impact and always make
sure that the entire gun is not exposed to impact or thrust. If in doubt, always check the
proper adjustment of the gun. The sightbody and the mounting of the lens may be cleaned
from dust and dirt by using a clean, soft cloth which has been dampened with water. The
lens may be cleaned from dust with a soft optical brush, while fingerprints and dirt can
be removed from it by using a lens cleaning cloth (moisturized with some lens cleaning
fluid).
turn elevation adjustment screw clockwise
turn elevation adjustment screw counter-clockwise
turn windage adjustment screw counter-clockwise
Always follow the rules for safe gun handling. Always ensure
that the backstop is adequate for your shooting, and always
wear protective shooting glasses.
- 3 -
Elevation
adjustment
��
��
Werbung
