Walther TOP POINT I Bedienungsanleitung Seite 2

2. Mounting
Your sight is delivered with a pair of mount rings which fit all
normal scope bases of the Weaver-type with a width of 22
mm. A minimum eye relief (the distance between the pupil
of the eye and the image lens) of 3 inches (7.5 cm) should
always be kept. Mount the sight onto your gun in a way that
the elevation screw is positioned on top of the gun, while the
windage screw is positioned on the right side of the gun.
3. Operation and adjustment
The combined on/off-rotary switch and brightness regulator
of the electronic Walther red-dot-sight "Top Point" is
positioned on the top side of the sightbody. When the switch
is on one of the positions between 1 and 11, a dot of light
of different intensity is projected onto the lens. The lowest
setting "0" is the "OFF" position. Simply place the dot over
the target when shooting.
3.1 Battery
Your Walther Top Point I red dot sight is powered by a 3
volt lithium battery (CR 2032 or similar type). If the red dot
gets slowly darker or even invisible then it is time for a
battery change. To insert the battery, unscrew the battery
compartment lid (cover of the on/off rotary switch) with a
coin while holding the serrated part of the knob. Insert new
battery with the positive pole (+) showing up, then replace
battery compartment lid.
- 2 -
battery
compart-
ment lid
Battery