Switching On/Off - Cocraft LXC Serie Original Bedienungsanleitung

Switching on/off

1. Slide the battery into the grooves of
the battery connection on the bottom of
the handle making sure that it clicks securely
into place.
2. Hold in the trigger safety catch on either
the right or left side. When the safety catch
is in the middle position, the trigger is
locked.
3. Pull the trigger to switch the saw on.
Release the safety catch and adjust
the blade speed using the trigger.
4. Turn the saw off by releasing the power
trigger.
Cutting flush to a surface
• By using a flexible bi-metal saw blade you can saw
flat against the face of a surface. This is useful when
sawing off pipes protruding from a wall for example.
• Lay the side of the saw blade flat against
the surface/wall and tilt the saw so that the side of
the footplate rests against the surface/wall.
• Lay a thin piece of hard plastic between the blade
and the surface to protect the surface.
Sawing corners
1. Mark the cut line clearly before starting to cut.
2. Line the tip of the blade along the cut line.
3. Rest the edge of the footplate on the workpiece
and hold the saw almost parallel to the workpiece
with the blade in the air.
4. Start the saw and let it come up to speed.
5. Slowly tilt the saw upwards so that the blade feeds
into the marked cut line.
6. Continue to tilt the saw upwards until it is at right angles to the workpiece,
cut until you reach the next corner.
Warning:
Do not feed the saw blade into the material until it has fully come up to the set speed
or serious injury may result.
8