Troubleshooting Guide - Cocraft LXC Serie Original Bedienungsanleitung

Troubleshooting guide

The saw does •
not start.
The saw is •
sluggish and/or
cuts out. •
•
Poor battery •
operating time.
•
The battery •
does not •
charge.
•
•
•
•
Responsible disposal
This symbol indicates that this product should not be disposed of with
general household waste. This applies throughout the entire EU. In order
to prevent any harm to the environment or health hazards caused by
incorrect waste disposal, the product must be handed in for recycling
so that the material can be disposed of in a responsible manner. When
recycling the product, take it to your local collection facility or contact
the place of purchase. They will ensure that the product is disposed of in
an environmentally sound manner.
Discharged or incorrectly inserted battery. Charge the battery
and ensure that it is properly connected.
Worn/damaged saw blade. Check the blade and replace it
if necessary.
Too much force applied. Decrease the applied force.
The battery might be overheated. Read the Overload protec-
tion and other safety features section.
The battery is not fully charged. A few charging cycles where
the battery is charged 100% might be needed before it reaches
full capacity.
The battery needs replacing.
The battery is not correctly inserted into the charger.
The battery or charger contacts are dirty. Disconnect the char-
ger from the power supply and clean the contacts.
The mains lead is not securely plugged into the wall socket.
Check that the wall socket is energised.
The charger or mains lead is damaged.
The battery needs replacing.
10