Machine Information - Ferm HDM1041P Übersetzung Der Originalbetriebsanleitung

Use of extension leads
Only ever use approved extension leads that are
suitable for the power rating of the machine. The
minimum core thickness is 1.5 mm
using a reel extension lead, always fully unroll the
lead.
Immediately switch off the machine when:
• Excessive sparking of the carbon brushes.
• Interruption of the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation.

2. MACHINE INFORMATION

Intended use
The demolition hammer is intended for
demolishing concrete, chiseling off concrete,
grooving and bar cutting.
This machine can only be used with
SDS-Max chisels.
Technical specifications
Mains voltage
Mains frequency
Power input
Impact rate
Impact energy
Weight
Sound pressure (L )
PA
Acoustic power (L )
WA
Vibration
Main grip a
h,Cheq
Auxiliary grip a
h,Cheq
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardized test given in
EN60745. It may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
4
• Using the tool for different applications, or with
. Whenever • The times when the tool is switched off or when
2
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-3
Fig. A
1. On/off switch
2. Speed adjustment wheel
3. Lock-on button
4. Chuck
5. Locking sleeve
6. Main grip
7. Auxiliary grip
8. Chisel position lock ring
9. Lubrication point
220-240 V ~
3. ASSEMBLY
50 Hz
1.500 W
1.000-1.900/min
6-25J
10.69 kg
Mounting and removing the accessory
102.13dB(A) K=3 dB(A)
Fig. B
105dB(A) K=3 dB(A)
20.38m/s K=1.5m/s
2 2
Mounting
19.61 m/s K=1.5m/s
2 2
• Apply a few drops of oil to the shaft of the
• Slide the locking sleeve (5) to the rear.
• Insert the accessory into the chuck (4).
• Release the locking sleeve (5).
Removing
• Slide the locking sleeve (5) to the rear.
• Remove the accessory from the chuck (4).
• Release the locking sleeve (5).
different or poorly maintained accessories,
may significantly increase the exposure level.
it is running but not actually doing the job, may
significantly reduce the exposure level.
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Do not use blunt drill bits or chisels.
Immediately sharpen or replace blunt
drill bits or chisels.
accessory.