Troubleshooting; Care And Maintenance - CO/Tech JD2837-UK Original Bedienungsanleitung

Troubleshooting

Problem Possible Cause
The machine No voltage in
does not the wall socket.
start.
Worn brushes.
Short circuit.
Faulty power switch.
The machine Dull or damaged
runs slowly. saw blade.
Speed too low.
The motor is overheated.
Strange Mechanical fault.
noise.
Faulty windings.
Heavy Loose blade.
vibration.
Sparks in Brushes jammed.
the motor.
Winding short circuited.
Dirty commutator.

Care and Maintenance

• Always keep the motor's ventilation openings free of dust and debris.
• Clean the machine regularly using a moist cloth and washing up liquid.
• Never use solvents.
Remedy
Check to see if there is power
at the power point.
Contact us in case of motor
or electrical faults.
Replace saw blade.
Alter the variable setting.
Do not press down too hard.
Contact us.
Tighten the tool and make
sure it is set correctly.
Contact us.
9