CO/Tech JD2837-UK Original Bedienungsanleitung Seite 5

f) Keep the tools sharp and clean. Properly maintained cutting tools with sharp
blades are less likely to jam and are easier to control.
g) Use the electrical hand tool, accessories and such according to the instructions
and in a way suitable for the type of electrical hand tool used. Using the electrical
hand tool for work other than that for which it is intended could result in
a dangerous situation.
5) Service
a) Repairs and service should only be performed by qualified persons, and only with
original spare parts. This guarantees the safety of the electrical hand tool.
Safety Instructions – Jigsaw EN 60745-2-11
Warning: Always disconnect the plug from the mains before adjusting, servicing or
performing maintenance on the machine.
1. Hold the power tool on isolated grip surfaces when there is a risk for the saw
blade coming into contact with hidden live wires or it's own flex. If the saw blade
comes into contact with live wires it may electrify the metal parts of the jigsaw
which can cause electric shock.
2. If the mains lead is damaged it should only be replaced by the retailer.
3. Keep your hands away from the blade and other moving parts.
4. Do not reach under the workpiece being sawed. Be extra careful if the blade or
your hand is out of sight. Make sure that the underside of the workpiece to be
sawn is free of obstacles.
5. Do not use blunt or damaged saw blades. Bent saw blades can easily break and
fly off.
6. Start the saw and let it run up to speed before starting to cut.
7. Make sure that the footplate is in constant contact with the workpiece during
sawing. Be extra careful when cutting with a tilted footplate as it is easy to exert
too much lateral force on the saw blade.
8. Secure the workpiece with a clamp, vice, etc.
9. Make sure that the settings are correct and that the blade sits securely in
the blade holder before sawing.
10. Make sure that the saw blade has come to a complete stop before removing
the saw from the cut. The saw blade should not be slowed down by applying
lateral force to the side of the blade.
5