Machine Information - Ferm HDM1040P Übersetzung Der Originalbetriebsanleitung

minimum core thickness is 1.5 mm
using a reel extension lead, always fully unroll the
lead.
Immediately switch off the machine when:
• Excessive sparking of the carbon brushes.
• Interruption of the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation.

2. MACHINE INFORMATION

Intended use
The demolition hammer is intended for demolishing
concrete, chiseling off concrete, grooving and bar
cutting.
Technical specifications
Mains voltage
Mains frequency
Power input
Impact rate
Number of chisel positions
Weight
Sound pressure (L )
PA
Acoustic power (L )
WA
Vibration
Main grip a
h,Cheq
Auxiliary grip a
h,Cheq
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with
a standardized test given in EN60745. It may be
used to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level.
• The times when the tool is switched off or
when it is running but not actually doing the
job, may significantly reduce the exposure
level.
4
. Whenever Protect yourself against the effects of vibration by
2
maintaining the tool and its accessories, keeping
your hands warm and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
page 2
Fig. A
1. O n/off switch
2. Power indicator
3. Lock-button
4. Chuck
5. Locking sleeve
6. Main grip
7. Auxiliary grip
8. Chisel position lock ring
9. Lubrication point
3. ASSEMBLY
220-240 V ~
50 Hz
1.200 W
3.100 /min
12
Mounting and removing the accessory
6.22 kg
Fig. B
94 dB(A) K=3 dB(A)
105 dB(A) K=3 dB(A)
12.550 m/s K=1.5m/s
2 2
15.876 m/s K=1.5m/s
2 2
Mounting
• Apply a few drops of oil to the shaft of the
• Slide the locking sleeve (5) to the rear.
• Insert the accessory into the chuck (4).
• Release the locking sleeve (5).
• Push the lock ring (8) forward and turn to
Removing
• Slide the locking sleeve (5) to the rear.
• Remove the accessory from the chuck (4).
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Do not use blunt drill bits or chisels.
Immediately sharpen or replace blunt
drill bits or chisels.
This machine is fitted with an SDS Max
chuck.
accessory.
desired position. Make sure the ring locks
back in place before using the machine.