Tack life S3-50 Bedienungsanleitung Seite 6

● Area Measurement
Press button
rectangle blinking on the display, please follow the below instructions for
area measuring:
Press once for length measurement
Press again for width measurement
The device calculates and shows the result in the major display area.
The resent measuring result of length is showed in the auxiliary display
area .
Press , clear off the result and measuring again if necessary.
Press again to exit the mode.
● Volume Measurement
Press button
shows on the top of screen. Please follow the below instruction for volume
measuring:
Press for Length measurement
Press again for Width measurement
Press thirdly for height measurement
The device calculates and shows the result in the major display area.
The resent measuring result of length is showed in the auxiliary display
area.
Press , clear off the result and measuring again if necessary.
Press again to exit the mode.
● Painter Function
When the meter is in area mode, you can use the add / subtract function
to total up the area of several surfaces.
Press button
Press to measure the height of the wall first;
Press to measure the bottom edge of the first wall, get the first area
in the major display area;
Press to measure the bottom edge of another wall, get the sum of
these two walls.
once, shows on the screen. One of the side of
twice to enter volume measurement mode. A
three times till showing in the display.
- 04 -
will