Tack life S3-50 Bedienungsanleitung Seite 5

● Changing Reference Point
Short press key to change the reference point. System default reference
point is under its bottom.
● Delaying Measurement
Long press , values shows in the screen. User can press
adjust the time of measurement between 3s to 60s.
Press to start, the measure start when the time turns to 0.
Back Light On / Off
●
The back light is set to turn on and off automatically. The back light can be
on for 15s while operating,and it will be shut off automatically in 15s when
there is no operation to the device.
● Sound on/off
Short press button
Self-Calibration
This function can keep the precision of the device automatically. Instruction:
Power off, press button
on the screen. User can adjust the figure with button
to the accuracy of the meter. Adjusting range: -9 to 9mm, then press button
to save the calibration result.
Length Measurement & Calculation
● Single Distance Measuring:
Short press
the button again for single measurement of length, then the measured
results will display on the major display area.
● Continuous Measurement:
Long press button
measuring mode. Maximum and Minimum measuring result will display in
auxiliary display area, current result will show in major display area. Short
press button
to turn on or off the buzzer.
and
to turn on the laser beam under measuring mode. Press
under measuring mode and enter into continuous
or to withdraw continuous measuring mode.
till "CAL" and a figure under it displays
- 03 -
or to
, according