Notes On Use - Sony WRT-800A Bedienungsanleitung

Notes on Use

On channel selection
•
Make sure that the channel selected on the microphone is
the same as that selected on the tuner used in the same
system.
•
Depending on the noise or interference conditions, the
selectable channels may not necessarily all be usable. If
necessary, you can determine the usable channels by
stepping the channel selection through a number of
channels on a tuner with the microphone set to OFF.
Those channels on which the RF indicator of the tuner
does not light are usable.
•
If there is a TV broadcasting station near by, do not use
the station's channel.
On microphone system operation
•
To operate with 2 or more channels, maintain a distance
of at least 30 cm (1 ft.) between each pair of microphones.
For details of operation with 2 or more channels, refer to
the Operating Instructions for the WRR-800A/801A UHF
Synthesized Diversity Tuners.
•
Ensure that the tuners set to channels not being used are
either turned off or set to the minimum output level.
•
When powering the microphone on or off, to keep the
noise to a minimum, set the audio output level from the
tuner or mixer to a minimum.
•
Powering the microphone on without checking the channel
selection first may interfere with the operation of other
microphones/transmitters, if the current setting is already
being used.
•
Separate the reception antennas and the microphone by
more than 3 meters (10 ft.).
On the antenna
Do not touch the antenna while using as it will significantly
degrade good performance, causing drop outs, etc.
S
9
EN