Cleaning The Unit; Operation; Specifications - IMG STAGELINE LED-620W Bedienungsanleitung

screws (2) at the bracket, adjust the desired incli-
nation and retighten the screws.
WARNING The unit must be mounted in a safe
and expert way. If it is installed at a
place where people may walk or sit
under, it must additionally be se -
cured [e. g. by a safety rope; lead the
safety rope through the ring screw
(6) and fix it so that the maximum
falling distance of the unit would not
exceed 20 cm].

5 Operation

WARNING Never look directly into the light
source, this may cause eye damage.
Please note that fast changes in
lighting, e. g. flashing light, may trig-
ger epileptic seizures with photosen-
sitive persons or persons with epi -
lepsy!
1) To switch on the unit, connect the mains cable
supplied to the mains jack (5) and the plug to a
socket (230 V~ / 50 Hz).
2) The unit responds to music via the microphone
(7) with alternate switching on and off of the
LEDs and motors as well as with changes of the
rotation directions of the mirror drums and
wheels. If the music control should not function
in an optimum way, increase the volume or
reduce the distance between sound source and
light effect unit.
If the microphone does not pick-up sufficient
sound, the LEDs and motors are switched off
after a few seconds.
3) To switch off the unit, disconnect the mains
plug from the socket.
For a more convenient operation, it is recom-
mended to connect the unit to a socket which can
be switched on and off via a light switch.
Caution: Do not connect the unit to the mains volt-
age via a dimmer!
For power supply of another light effect unit the
mains output jack (8) may be used when the total
power consumption does not exceed the rated cur-
rent of the fuse in the fuse support (4) [
and imprint on the unit]. The connection can be made
e. g. via the mains extension cable AAC-170 / SW
from MONACOR. Thus, several LED-620W units
can be connected with each other.
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.

6 Cleaning the Unit

The lenses and mirrors should be cleaned at regu-
lar intervals, depending on impurities caused by
dust, smoke or other particles. Only this will ensure
that the light is radiated at maximum brightness.
For cleaning, disconnect the mains plug from
the socket. Only use a soft, clean cloth and a
detergent for glass. Then carefully wipe the parts
dry.
use a soft, clean cloth. Never use any fluid; it may
leak into the unit and cause damage.

7 Specifications

Power supply: . . . . . . . . . 230 V~ / 50 Hz
Power consumption: . . . . 80 VA
Light source: . . . . . . . . . . 2 extra bright 10 W
Ambient temperature: . . . 0 – 40 °C
Dimensions (W × H × D): . 34 × 22 × 38 cm
Weight: . . . . . . . . . . . . . . 5 kg
Subject to technical modification.
type label
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
®
For cleaning the other parts of the housing only
LEDs (white)
GB
7