Axis Q6055-C Bedienungsanleitung Seite 29

AXIS Q6055-C PTZ Dome Network Camera
Each RJ45 and SFP port has its own dip switch. The dip switches control how the port forwards
data. For more information, see page 29.
I/O terminal connector
6-pin configurable I/O terminal block, which is connected to the camera through the multicable.
Use with external devices in combination with, for example, tampering alarms, motion detection,
event triggering, time lapse recording and alarm notifications. In addition to the 0 V DC
reference point and power (DC output), the I/O connector provides the interface to:
• Digital output – For connecting external devices such as relays and LEDs. Connected
devices can be activated by the VAPIX® Application Programming Interface, output
buttons on the Live View page or by an Action Rule. The output will show as active
(shown under System Options > Port & Devices > Port Status) if the alarm device
is activated.
• Digital input – An alarm input for connecting devices that can toggle between
an open and closed circuit, for example: PIRs, door/window contacts, glass break
detectors, etc. When a signal is received the state changes and the input becomes
active (shown under System Options > Port & Devices > Port Status).
6-pin terminal blocks for:
• Digital Input/Output
• Power (DC output)
• 0 V DC (-)
Function
0 V DC (-)
DC output
Configurable
I/O 1 (Input or Output)
Configurable
I/O 2 (Input or Output)
Network connector dip switches
Important
Always use the default dip switch setting (position B) if the relationship between devices in
the system is not defined.
Pin Notes
1, 4, 6
2
Power out
3 Digital input
Digital output (transistor –
open collector)
5
Digital input
Digital output (transistor –
open collector)
29
Specifications
0 V DC
12 V DC, 50 mA
0 to max 30 V DC
0 to max 30 V DC,
open drain, 100 mA
0 to max 30 V DC
0 to max 30 V DC,
open drain, 100 mA