Atag WV6311NM Anleitung Seite 27

INSTALLATION
Installation
5
Drilling the support surface and fitting the Hood
• The hood can be fitted directly on the lower surface of the wall units
using the snap-on Side Supports.
• Make an opening on the lower surface of the wall unit, as indicated.
255
• Screw the closing profile 20 onto the rear part of the hood, using
the screws 12e (2.9 x 12.7) provided.
• Open the glass panel.
• Remove the metal grease filters one by one by turning the hooks
provided.
• Close the glass again.
• Insert the hood until the snap-on side supports click into place.
• Open the glass panel.
• Lock in position by tightening the screws Vf from underneath the
hood.
Vf
EN 13