List Of Included Parts; Before Installation - Mitsubishi Electric VL-100U5-E Installationsanleitung

■ Mounting position diagram (seen from inside)
Mounting plate
Air exhaust hole
(ø85 to ø90 wall hole)
Power and connection
cable pullout area
(VL-100EU -E only)
5

List of included parts

Pipe mounting plates (2)
Air supply/exhaust pipes A (2)
Air supply/exhaust pipes B (2)
Wood screws (9)
(for attaching the mounting plate)
Aluminium tapes (2)
Weather covers (2)
Flange nuts (2)
Weather cover mounting plates (2)
Weather cover mounting screws (4)
Edge of main unit Mounting hole 36 – ø6
75
(Adjustable)
22
277
(min.)
360
Require to be secured
420
(min.)
200 75
(Adjustable)
(max.)
350
530
554
620
(min.)
360

Before installation

Remove the two screws securing the main unit to
remove the mounting plate.
Note
- Keep the screws for securing the main unit
in a safe place. Screws are needed when the
main unit is installed.
- Lossnay surfaces are glossy, so be careful
not to scratch them. Spread out cardboard or
the like, lay the vinyl sheeting used to pack
the main unit on top of it, and with the main
unit placed upside down as shown in the
drawing, remove the mounting plate.
- The shutter of the Lossnay is closed for
shipment.
Screws for securing
main unit
Main unit
Spread cardboard
or a similar
material
Eng-3
Air intake hole
(ø85 to ø90 wall hole)
Unit (mm)
Mounting plate
Vinyl sheeting