Allonge ALG-KW1102EU Bedienungsanleitung Seite 12

• Never use juice or other drinking fluids, hot water (40°C or higher), or water mixed
with chemical products, fragrances (such as aroma oil), or cleanser.
Before Requesting Repairs or Service
WARNING
This product can be disassembled and repaired by qualified repair technicians only.
If you find any problems, follow the troubleshooting procedures below.
Problem
The power does
not turn on.
No mist is formed,
or the amount of
mist is small.
The Water
indicator stays lit
in red even when
water is supplied.
Even when its
operation is
stopped, it sounds
like it is operating.
A smell is emitted.
The mist nearly
stops once every
minute.
03_ALG-KW1102EU_3L_EnFrGe.indb En 12 03_ALG-KW1102EU_3L_EnFrGe.indb En 12
Primary cause
• Is the power cord plugged
into the outlet?
• Is the Water indicator lit
red?
• Is it time (about 3,000
hours) to replace the
ceramic disc (ultrasound
vibration plate)?
• Is the water tank loaded
in the humidifier so that it
fits securely?
• This is not a malfunction.
• Are you using water other
than clean water?
• This is not a malfunction.
En 12
Remedy
Plug the power cord into the outlet.
Fill with water.
If the service life of the ceramic disc
is exceeded, the amount of mist
generated can drop or fail to be
generated at all. Repairs are needed, so
consult with the Service Center.
Load the water tank so that it fits
securely.
After misting stops, the fan runs for
about one minute before the humidifier
comes to a complete stop.
Drain the water left in the water tank,
and clean by following the procedure in
"Cleaning and Storage".
To prevent water from collecting at
the mist outlet, the fan motor stops
operation about once every minute,
and the fan stops for about two
seconds.
English
2012/06/20 18:47:12 2012/06/20 18:47:12