Special Functions; Error Handling - Car-O-Liner CMI 300 PULSE Betriebsanleitung

Special functions

Software / Licenses
I
Torch setup
I

Error handling

CMI Pulse has a sophisticated built-in self-protection system. The machine automatically stops the gas supply, interrupts the welding
current and stops the wire feeding in case of an error.
Selected errors:
Gas control error (IGC)
A gas control error can be due to too low or too high gas flow.
Check that the pressure of the gas flow is higher than 2 bar and lower than 6 bar, corresponding to 5 l/min and 27 l/min.
Correct the gas error by adjusting the manual gas flow to 27 l/min. Reset the the gas error by briefly pressing the
Error log
I
II
II
II
III
III
III
Error log
All errors are saved in the
machine error log in the
menu Service. The error
log can be distributed, by
inserting an SD-card and
pressing the following
key:
The error log is now
saved at the SD-card.
Reset the error log by
pressing the trash bin
key.
15
P
-key.