Alarm - auna Vertiplay Bedienungsanleitung

EN
26
short press the 10+/FOLDER+ button 10+ to select songs.
Other
• Reading USB mode, LCD flash display "- - -"
• After reading the total number will automatically play.
• NO USB or can't reading USB, LCD will display "NO USB".
AUX function
1. Press the POWER/SOURCE button to switch AUX function,LCD
displaying "AUX".
2. Insert an external source at the LINE IN jack.
BT
1. Press POWER/SOURCE button to power on. Switch to BT function. The
LCD flashes slowly "bt".
2. If the pairing has been successful, an accousting signal will sound. When
disconnecting another sound indicates the .
3. LCD before connecting the BT device "bt" characters on the slow flash,
through a BT device set PAIR, long after the connection is successful "bt",
long press PAIR disconnected, "bt" slow flash.
4. By mobile phone equipment operation you can select play, pause,
volume control. Short press VOL VOL + or - button can control the size of
the volume.
5. Automatic connection: KCR001 first pair with the same BT device, the
boot into the BT mode, again KCR001 automatically search paired BT
devices, and automatically connected with them..

ALARM

1. Make sure the unit is in power off (standby) mode before setting. Short
press the ALARM Button,until the alarm icon and hour digital display
begins to blink,then release the button.
2. Short press the SKIP± Buttons to adjust the hour.
3. Short press the ALARM Button,until the minute digital display begins to
blink.
4. Short press the SKIP± Button to adjust the minute.
5. Short Press the ALARM Button to finish setting the time,then "BUZZER"
digital display begins to blink.
6. Short press the SKIP± Button to switch between Buzzer,FM,CD,USB