Indicators And Controls; Installation; Maintenance - Chattanooga Group Hydrocollator SS-2 Bedienungsanleitung

E-1 Unit - Adjustment is accomplished by placing the rack insert (sheet metal) in or leaving the insert out. With the
insert in, the rack accommodates four standard size packs.
E-2 Unit – Adjustment is accomplished by inserting the hanging platform. The E-2 unit comes complete with two
oversize, three standard and one Neck Contour Pack.
SS Unit – Holds eight standard size HotPacs. Special rack holds two Neck Contour Packs.

Indicators and Controls

WHITE LAMP: (on 120 volt units of the M-2 model) or
GREEN LAMP: (on 220/240 volt units), when illuminated, indicates that main power is connected, the switch is ON and
unit is operating.
RED LAMP: (if applicable), when illuminated, warns of an overheat/low water condition. Action is necessary to rectify
the condition.
IMPORTANT: Some models are fitted with a thermal cut-out thermostat which acts as a "Non self-resetting" thermal cut-
out. In the unlikely event of a fault condition occurring, this device is designed to open the power circuit between
180°F to 185°F (82°C to 85°C). It is NOT possible to alter its operating range. The operation of the unit may be restored
by depressing the red button after the water/element temperatures have been allowed to cool. If the fault condition
persists, please contact Chattanooga Group, Inc. or an authorized agent.
Explanation of Symbols
ATTENTION:
Type B equipment:
DANGER:

Installation

Remove all of the contents inside the Hydrocollator and then replace the wire rack and install Hotpacs. Make certain
the drain valve is closed before filling the tank with water. The tank may be filled from any standard type faucet.
Check the voltage rating on the serial decal plate which is located on the back of the unit. To turn the unit on, simply
plug the unit into a 120 Volt~, 60 Hz outlet or a 220-240 Volt~, 50-60Hz outlet as indicated on the decal plate. To turn
the unit off, simply unplug from mains power supply. DO NOT attempt to use direct current. Follow the procedures
indicated in the Precautionary Instructions. DO NOT attempt to use the unit if it is not properly grounded.

Maintenance

Care and Cleaning of your Hydrocollator Heating Unit
The Hydrocollator is equipped with an immersion type heating element and a hydraulic capillary type thermostat which
evenly maintains the HotPac temperature in the water and provides a ready supply of heated packs. It is critical to
maintain the water level over the top of the HotPac to avoid damage to the heating element, the stainless steel, or
the HotPac. Water is constantly lost during operation due to evaporation. Therefore, it is essential that water be added
daily. The tank should also be drained and cleaned systematically, at a minimum every two (2) weeks.
Always unplug the unit from its electrical service when emptying or cleaning the unit. Drain unit by the drain valve
located at the bottom rear of the unit. Either move the unit to a floor drain or attach the extension hose to it when
draining.
Your Hydrocollator Heating Unit is made of high quality stainless steel that should last a lifetime. That is Stainless, not
Stainproof steel. You must properly care for your Hydrocollator Heating Unit if you wish for it to last a lifetime. And it will.
Consult accompanying documents
Denotes the degree of protection against electric shock, particularly regarding allowable
leakage currents and the reliability of the protective earth connection.
Risk of explosion if used in the presence of flammable anesthetics.
8