Electrical Connection; Electric Shock - AFRISO CapFox ENT 7 Betriebsanleitung

6

Electrical connection

ELECTRIC SHOCK

• Verify that the degree of protection against electric shock (protection class,
double insulation) is not reduced by the type of electrical installation.
Failure to follow these instructions will result in death or serious injury.
ELECTRIC SHOCK CAUSED BY LIVE PARTS
• Disconnect the mains voltage supply before performing the work and ensure
that it cannot be switched on.
• Verify that no hazards can be caused by electrically conductive objects or
media.
Failure to follow these instructions will result in death or serious injury.
1. To open the housing of the control unit, loosen the four cover screws and
remove the cover of the housing.
2. Pull the plug terminals from the printed circuit board (perpendicularly with
reference to the printed circuit board.
- Verify correct terminal assignment.
3. After connection, plug the terminal back tightly onto the PCB.
4. Tighten the cable glands properly.
5. Seal unused cable glands or replace them by blind plugs.
6. Refit the housing cover and close it with the four housing cover screws.
Electrical connection
DANGER
DANGER
CapFox® ENT 7
EN
18