Velleman WCM2 Bedienungsanleitung Seite 2

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal
of the device after its lifecycle could harm the environment. Do
not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for
recycling. This device should be returned to your distributor or to a
local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying a Velleman product! Please read the manual
thoroughly before bringing this device into service. If the device was
damaged in transit, don't install or use it and contact your dealer.
2. Operation
Insert 1 AA-battery of 1.5V in the battery compartment. Respect the
polarity indications.
Remove all dials before attaching the WCM2 to the clock with 2 screws
(not included) or clicking it into place. Mount the two rotary switches
on the back of the device and put the alarm "ON/OFF"-switch in the
"ON"-position.
Turn the rotary time-setting switch at the back (marked by two clock
hands on the housing) clockwise and stop turning immediately when
you hear a click and the alarm is activated: this is the WCM2's "alarm
point". Assemble the yellow hand (alarm): place it directly at 12
o'clock. In doing so, the user should neither push the hand with his
fingers nor use the rotary alarm-setting switch at the back (indicated
by the clock symbol on the housing) to move the yellow alarm hand.
Consequently, the user should do the same for the green hour hand,
the green minute hand and the red seconds hand. All four hands are
now fixed at 12 o'clock.
It is now possible to test the accuracy of the alarm time. Use the rotary
time-setting switch at the back to advance the hands clockwise until
the 12 o'clock position is reached again. The user should hear the click
WCM2_v2
ENGLISH
2 VELLEMAN®