Troubleshooting - Philips AZ1008 Bedienungsanleitung

XP AZ 1008/00-1 22-11-2000 21:02
If a fault occurs, first check the points listed below before taking the set for repair. Do
not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee.
Problem
No sound
No power
Display does not function
properly/ No reaction to
operation of any of the
controls
Er indication
CD playback does not work
The CD skips tracks
Poor cassette sound quality
Recording does not work
Pagina 13

Troubleshooting

Solution
– Adjust the VOLUME
– Mains lead not securely connected.
Connect AC mains lead properly
– Batteries exhausted /incorrectly inserted.
Insert (fresh) batteries correctly
– Electrostatic discharge
Switch off and unplug the set. Reconnect after a few
seconds.
– No CD inserted, insert a CD
– CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
– CD-(R) is blank or the disc is not finalized.
Use a finalized CD-(R)
– Laser lens steamed up.
Wait until lens has cleared/acclimatized
– CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
– CD damaged or dirty. Replace or clean CD.
– Programme is active. Quit programme mode
– Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
– Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording
– Cassette tab(s) may be broken. Apply a piece of
adhesive tape over the missing tab space.
13