Set K0; Position; Signal Level - TR-Electronic I__-582 Serie Benutzerhandbuch

Parameterization via TRWinProg

5.2.4 Set K0

This function is not available in the magnetic code disc variant IP_58_.
The Set K0 function only can be executed if the input signal is present statically for
>50 ms at the input. After approx. 0.5 s the zero pulse signal at the output is set. If the
Set K0 function input is not used, he should be disabled to suppress interference.
Selection
In use
Not in use

5.2.5 Position

In the online state in the field Position the current measuring system position in
steps is displayed.
Resultant impulses = Number of steps/4
With entering of a value into the field Position the measuring system can be
adjusted on the desired position value. The new position is set if the function Data
write to device is executed.
Lower limit
Upper limit

5.2.6 Signal level

Selection
Supply voltage
TTL
 TR-Electronic GmbH 2015, All Rights Reserved
Page 34 of 35
Risk of injury and damage to property by an actual value jump when the
Set K0 adjustment function is performed!
 The Set K0 function should only be performed when the measuring system
is at rest, otherwise the resulting actual value jump must be permitted in
the program and application!
Description
Set K0 function active
Set K0 function inactive
Risk of injury and damage to property by an actual value jump when the
adjustment function is performed!
 The adjustment function should only be performed when the measuring
system is at rest, otherwise the resulting actual value jump must be
permitted in the program and application!
0
(programmed number of impulses/revolution * 4) – 1
Description
Output driver: Push-Pull; Level = Supply voltage
The supply voltage must be > 8 VDC
Output driver: RS422; Level = 5 VDC
TR - ECE - BA - DGB - 0119 - 04
Default
X
Printed in the Federal Republic of Germany
07/11/2018