Junkers EU 2 D Anleitung Seite 15

In Combination with the
TA 213 A (and NTC Storage):
– Set channel 1 of the timer to heat-
ing from 00.00 to 23.59 hrs.
Channel 1 is in operation during
the heating time of both channels
of the TA 213 A.
3.3.5 Setting the Daily Program
The daily program sets switching pe-
riods for single days (e.g., the week-
end) that deviate from the weekly
program. Unused switching peri-
ods must be deleted!
Note: After the entry of a daily pro-
gram, the weekly program can no
longer be changed.
All programs must then be deleted
(clear button CL) and the switching
timer reprogrammed.
– Press and hold the ∆ button (ri).
– Set the arrow
to the desired weekday (e. g., 7. =
Sunday).
– Press and hold the
the switching period that is to be
changed.
The switching time of the weekly
program is displayed.
– Set the switching time with the
knob (rf).
– Release the
– Press and hold the
located directly below.
The switching time of the weekly
program is displayed.
with the knob (rf)
button (rd) of
button (rd).
button (re)
– Set the switching time with the
knob (rf).
– Release the
– Change other switching periods in
the same way if required.
Deleting unused switching
periods:
– Press and hold the
the switching period that is not
necessary.
– Turn the knob (rf) to the left until
the display shows four lines
(Fig. 12).
– Release the
– Repeat the process for the
ton (re) located directly below.
Completing the setting:
– Briefly press the time setting but-
ton (rh).
The daily program is stored and the
current weekday is displayed.
Note: When no entry is made for ap-
prox. one minute, the display chang-
es automatically back to the current
weekday.
EU 2 D
button (re).
button (rd) of
button (rd).
but-
15