Filter Change; Toubleshooting; Technical Specifications - Guzzanti GZ-999 Gebrauchsanleitung

POWER: When the plug is connected, power button will be on and showed red color. Touch POWER,
the Low speed symbol will be lighted, and machine start working. After 15 seconds, the LED
background light off. Re-touch POWER again, then the background light will be on and other bottom
can be working.
ANION: Touch the ANION, the Anion symbol will be on, the Anion start working. Re-touch ANION, the
function stop working.
SPEED: The machine is working in low speed after start working, one fan symbol is on. When touch
SPEED, it changes to middle speed, two LED symbols are on. Touch again, it changes to high speed,
three LED symbols are on. Touch the third times, it changes to night mode, night mode "S" LED
symbol is on.
TIMER: Touch TIMER, the timer LED symbol will be on, and it can be setting timer 2H,4H,8hours.. If
the machine is restart working, timer should be reset.

4. FILTER CHANGE

If the filter is very dirty or need to be changed. When change filter, please open the top cover, take
out of the front cover. Take out the filers from the framework, put in new ones. Then put back to the
machine. Cover the top cover.

TOUBLESHOOTING

If your air purifier is not working correctly, please check the following causes:
Trouble
No power
Not working
Unusual noise
Remote controller not working

TECHNICAL SPECIFICATIONS:

1. Input voltage: AC 220V-240V
2. Frequency: 50 / 60Hz
3. Consumption power: ≤30w
4. Negative ions: 3.0 million / cm³
5. Applicable area: 50 - 60m²
6. Remote control distance: ≤6m
7. Operating condition: Temperature: -10°C ~55°C Humidity: ≤95%RH
Possible reasons
Fault in power source
Plug not connected
Fault in electric circuit
There is foreign body in the
machine
Dirty filter
Battery run out of power
4
Shooting Way
Switch on when the power
source get regular
Insert the plug again
Try again in other place
Take to service center.
Replace the filter
Change battery