05. Operation
WARNING! Make sure to select the right voltage.
The voltage switch must point to the relevant voltage at your
current location!
NOTE: Before using for the first time, switch the device on for a few
minutes and allow it to run at the highest speed and temperature
settings. As a result of the manufacturing process, a slight odour may be
produced. This is not harmful and only occurs during initial use. Ensure that
the room has good ventilation.
Switching on/off and controlling air flow
1. Insert the mains plug into an easily accessible socket.
2. The on/off switch and switch for the power settings allows you to switch
the device on and select the desired power setting:
0 (off)
1 (slow air flow, lower temperature)
2 (fast air flow, higher temperature)
3. After drying, set the on/off switch to 0 (off) and pull out the mains plug.
20