Yedoo ALLOY WOLFER Bedienungsanleitung Seite 4

Installation manual
1. 2.
The installation is the same for both First, check that the front fork of the
models (Wolfer, Trexx), it differs only in scooter is aligned correctly (the V-brake
minor details (see additional pictures). shoulders should be pointing forwards
When tightening the connections do not
towards the front of the scooter), then
exceed the specified tightening torque. release the brake jaws by rotating
the lever.
Installing the front wheel
Insert the quick release mechanism into
the wheel ensuring that on both sides of
the wheel the narrow ends of the springs
face the centre of the wheel.
4. 5.
5–6 Nm
Tighten the adjustment nut of the Handlebars installation
quick release mechanism to the correct
position. When it is in the correct Insert the handlebars on the stem
position you will feel a noticeable and tighten the screws of the sleeve.
resistance just before you close the The labels (not shown in a picture)
mechanism completely. Close the quick should be clearly visible from the
release lever in a position where it does front view.
not touch the fork and simultaneously
it cannot be opened accidentally
while riding.
EN
3.
Direction
of rotation
Insert the wheel into the front fork so it
is exactly in the middle. Caution: When
inserting the wheel, ensure that the
arrow on the tyre sidewall points in the
direction of rotation when the scooter
is rolling forwards.
Trexx
Wolfer
5–6 Nm
6.a
2
1
Installing the rear wheel
Release the brake cable from the guide
(1). Put the wheel in one of the two fork
dropouts (see 6.b, 6.c.) then centre the
wheel and tighten the quick release
mechanism (2).
7.a
6–8 Nm
1
5–6 Nm
Adjusting the height of the handlebars
Loosen the screws on the stem and
adjust the handlebars to the desired
height using spacer rings. To set the
handlebars to the lowest position,
turn the stem so it points downwards,
see fig. 7.c. After adjusting the handlebar
height, first tighten the head-set screw
(1), then the side screws (2, 3).
6 7
6.b
Two-position rear fork enables you to
adjust the height of the footrest above
the ground. Use the lower position
for riding over a rough terrain. Close
the quick release lever. It should point
upwards.
7.b
2
3
7.c
6.c
The upper fork position, which reduces
the height of the footrest, is designed for
riding on a smooth, flat surface. Riding
will be less physically demanding. The
closed quick release lever should point
downwards.
7.d
EN