HQ Power VDP250MH7 Bedienungsanleitung Seite 3

a) DMX Values per Channel
Channel 1 Colour
Channel 2 gobo
Gobo rotation
Channel 3
Shutter
Channel 4
Channel 5 Pan - movement
Channel 6 Tilt - movement
Channel 7 Effect wheel
b) DMX512 Connection
Connect the provided XLR cable with the female 3-pin XLR output of your
controller and the other side to the male 3-pin XLR input of the VDP250MH7. You
can connect multiple VDP250MH7's in series. Use a screened cable with XLR
input and output connectors. Please refer to the figure at the right.
c) DMX-512 Connection with DMX Termination
A DMX terminator is recommended for installations where the DMX cable has to run a long
distance or is in an electrically noisy environment (e.g. discos). The terminator prevents
corruption of the digital control signal by electrical noise. The DMX terminator is simply an
XLR plug with a 120 resistor between pins 2 and 3, which is then plugged into the XLR
output socket of the last device in the chain. Please refer to the figure at the left.
VDP250MH7
0 - 7
8 - 15
16 - 23
24 - 31
32 - 39
40 - 47
48 - 55
56 - 63
64
65 - 72
73 - 80
81 - 88
89 - 96
97 - 104
105 - 111
112 - 120
121 - 127
128 - 191
192 - 255
0 - 15
16 - 31
32 - 47
48 - 63
64 - 79
80 - 95
96 - 111
112 - 127
128 - 191
192 - 255
0 - 135
136 - 255
0 - 133
134 - 244
245 - 249
250 - 255
0 - 255
0 - 255
0 - 255
3
White
UV blue
Pink
Green
Orange
Blue
Yellow
Magenta
White
Magenta
Yellow
Blue
Orange
Green
Pink
UV blue
White
Slow-fast rotation up
Slow-fast rotation down
Open gobo
Gobo 1
Gobo 2
Gobo 3
Gobo 4
Gobo 5
Gobo 6
Gobo 7 - mag.
Rot. gobo up
Rot. gobo down
Slow-fast rotation up
Slow-fast rotation down
Open shutter
Fast-slow shutter
RESET
Open shutter
360°
270°
Sl-fast 3-facet prism
VELLEMAN