Oranfresh EXPRESSA PROFESSIONAL Bedienungsanleitung Seite 18

This machine is covered by warranty for any defect in material for a
period of 2 years or 8000 servings from the date of the purchase. The
warranty is not valid if the damages are caused by improper use, or by
incorrect installation or circumstances beyond one's control. This
machine is not suitable for industrial usage and it shall not be used for
more than 1 hour continuously. Warranty coverage may differ in its
particulars from one country to another.
FAILURE POSSIBLE REASON
The machine is not connected with the
outlet
The switch has not been
enabled
The machine does
not
start
The upper cover of the machine is open
Fuse or other electric or mechanic parts
damaged
The knife cover "M" of the machine is
open
The machine does
not
The waste compartment is full
start and emits a
sound and jams
during the
squeezing
The peels photocell is dirty
phase
There is not the star
The oranges are not
squeezed enough
The small perforated cylinder "6" has
holes clogged
The component "1"
Presence of seeds on component "1"
does not insert
correctly
The machine doesn't
some internal parts are missing
correctly work
Blocco Palma I Zona Industriale – 95030 Catania (Italy)
Tel. 80006677 +39 095 291233 Fax. +39 095 291117
FOR SERVICE:
18
WEB: www.oranfresh.com
10- WARRANTY
"4"
base
AAT ORANFRESH S.p.A.
email: info@oranfresh.com
www.expressabyoranfresh.it
POSSIBLE SOLUTION
Connect the machine to an outlet
Enable the switch positioned
on the front panel of the machine
On/Off
The upper transparent cover of
the machine is open
Check that orangesare not stuck
in the cutting area to prevet the
coorec positioning of the cover
Contact service assistance
Place the Knife cover "M" and
ensure that its key make a click.
Move forward-backward the
handle on the left front side to
spread the spent peels
Empty the waste compartment
Clean the photocell positioned on
the back internal panel of the
discharging chute
Insert the star "4" following the
reassembling procedure
Clean the small perforated
cylinder "6"
Remove possible seeds from the
component "1" base
Check that all the components
are correctly placed, following the
procedure of reassembling of this
manual