Technical Specifications - ECG XENON C 222 Bedienungsanleitung

Symptom
The remote
controller does not
work

TECHNICAL SPECIFICATIONS

Power input
Standby power input
Operating conditions
CD
Tuner
Power output (max.)
Frequency characteristic
Cause
• There are no batteries in the
remote controller.
• The batteries are dead.
• The remote controller is not
directed at the remote controller
sensor.
• The remote controller is outside of
its operating range.
• The device is turned off .
Power
Temperature
Relative humidity
Frequency characteristic
S/N ratio (fi lter A)
Dynamic range
Distortion and noise
Fluctuation
FM band range
Correction
• Insert two AAA/1.5 V batteries.
• Replace the batteries with a new
set.
• Make sure the remote controller
is directed at the remote
controller sensor.
• Make sure the remote controller
is close enough to the device.
• Turn the device off and unplug
from the socket. Turn the device
back on.
AC ~100–240 V, 50/60 Hz
20 W
< 0.5 W
-10 °C ~ +35 °C
5 % ~ 90 %
20 Hz ~ 20 kHz
>80 dB (1 kHz)
70 dB (1 kHz)
-60 dB (1 kHz)
Under measurable level
87.5 ~ 108 MHz
5 W × 2
±1.5 dB (20 Hz ~ 20 kHz)
EN
47