Troubleshooting - ECG XENON C 222 Bedienungsanleitung

NOTE: In FM radio mode, buttons VOLUME+/-, MUTE are also active. For more information see "CD control".

TROUBLESHOOTING

Before bringing the device to the repair centre, please check the following table.
Symptom
No power
Sound
No sound or distorted
sound.
Cannot play disk
After connecting
a USB device, the
device stops working
The buttons on the
device do not work
EN
46
Preset stations can be selected via numerical buttons.
For example, pressing 2 will select preset 2. To tune preset 15, fi rst press 10+ and then 1
and 5.
Press to skip to next preset.
Press to skip to previous preset.
• The power supply is not properly
connected to the socket.
• Audio cables are not connected
properly.
• The volume is set to min.
• The sound is muted.
• The disk is inserted improperly.
• The parent lock classifi cation
coded on the disk is higher than
the parent lock level set on the
device.
• The disk is not compatible with this
device.
• The disk is contaminated.
• The connected USB device most
likely is a certifi ed type.
• The device is experiencing
interference caused by static
electricity etc.
Cause Correction
• Check the proper connection of
the power supply.
• Connect the audio cables
properly.
• Increase the volume.
• Press MUTE on the controller to
activate the sound.
• Press PLAY/PAUSE.
• Make sure the disk is inserted
with the label facing upward.
• Change the parent lock settings.
• Clean the disk
• The device does not play
uncertifi ed USB devices. In case
the player stops working, turn
it off , unplug the power cord
from the socket and remove the
USB device. Plug the power cord
back in. The device should work
normally.
• Turn the device off and unplug
from the socket. Plug the power
cord back in and turn on the
device.