Connection; Using The Remote Controller; Inserting The Batteries - ECG XENON C 222 Bedienungsanleitung

CONNECTION

Speakers output
Plug the speakers into the respective speaker terminals using audio
cables (white to +, red to -).
LINE IN
This device is equipped with audio input connectors which can be
used to lead an analog stereo audio signal to the device from external
systems, such as VCD or CD players, video cameras or MP3 players etc.
Using an audio cable with CINCH connectors (red for right channel,
white for left channel), connect the output terminals of the external
player with the LINE IN input of this device.
You can listen to music from the connected external source by pressing
the SOURCE on the device or remote controller.

Using the remote controller

Insert batteries into the remote controller. Direct the controller towards the remote controller sensor on the
head panel. The remote controller operates with a reach of 8 metres under a maximum angle of 30 degrees
horizontally.

Inserting the batteries

1. Remove the cover
of the battery
compartment on the
back side of the remote
controller.
Note:
• If you do not plan to use the remote controller for a longer period of time, take the batteries out.
• Do not combine old and new batteries or diff erent types of batteries.
• Dead batteries can leak and damage the remote controller.
• Do not expose batteries to excessive heat, e.g. direct sunlight, fi re etc.
• Be considerate towards the environment and dispose of old batteries according to local valid regulations.
2. Insert two AAA/1.5 V batteries into the battery
compartment. Make sure the battery polarity
correct, marked + and - on the inside of the
battery compartment with symbols.
Speakers
Speakers output
3. Return the cover
to its place.
43
EN