Diamond DC-13LV Original Bedienungsanleitung Seite 15

least 15 minutes and consult a physician. In case of skin contact, wash thoroughly with
soap and water. In case of ingestion, consult a physician immediately. Do not induce
vomiting.
1. Oil should be warm but not hot.
2. If piston is still moving, pinch a piece of rebar, just stopping before it actually breaks
off. (It is a 1/2 movement of piston.)
3. Unplug tool from the power source.
4. Remove oil-plug and seal-washer (packing).
CAUTION: Never remove oil-plug when unit is hot or oil will spurt out.
(DC16W)
5. Check that oil is level with bottom of plug hole (i.e. that pump case if full to the
brim). If oil level is low, top up with fresh hydraulic oil with anti-foam and anti-
abrasion properties (ISO viscosity grade VG46, e.g. Tellus46 (Shell), DTE-25
(Mobil) or Uni-Power VG46 (Esso).
6. After topping up, extract air from system. Gently tilt tool lengthwise and return it to
a level position. Top up again and tilt in the opposite direction. Repeat this process
until all air has been extracted.
CARE: Tool cannot function properly if oil contains air bubbles.
7. Replace oil-plug. The operation is now complete.
8. If oil level is too low, replace the oil-plug and lightly tighten. Then connect the tool
to power outlet. Switch "ON" to extend piston then release the switch when it has
reached its full stroke.
9. When the piston is completely retracted in the start position. Disconnect the tool from
the power supply. And remove the oil-plug to let overflows oil with air (bubbles).
10. Gently tilt tool lengthwise and return it to a level position. Slowly fill the tool with
fresh oil again. Replace the plug and lightly tighten, connect the tool to power supply
and advance the piston a few millimeters. Again, remove the oil-plug. Top up oil-
level and replace the plug.
(DC-20HL)
12