Diamond DC-13LV Original Bedienungsanleitung Seite 11

(grounded) power tools. The plug must be connected to a properly grounded
outlet. Do not use any adapter plugs with earthed (grounded) power tools.
Unmodified plugs and matching outlets will reduce risk of electric shock. (See
GROUNDING page 5)
2. WARNING: Wear safety goggles, safety glasses with side shields or a face shield
when using these tools.
3. Check that the power source is appropriate to the tool.
CARE: If voltage is too high, the motor will burn out. If voltage is too low,
insufficient power will be generated. Never use DC current.
4. WARNING: Avoid accidental starting. Ensure the switch is in the off-position before
plugging in.
DC-20WH and DC-25X:
To disengage lock, pull trigger switch, lock pin will pop out.
Do not attempt to cut rebar by locking the ON/OFF switch to the ON position. This
locking procedure is to be used only to warm the tool in cold climates. This is a safety
issue and may cause damage to your Rebar Cutter. Always pull the ON/OFF switch
by hand for each individual cut.
5. Check that cord is undamaged and that plug is not loose.
CAUTION: Cut or abraded covering could result in a short and electric shock to
operator
6. Check and keep work area clean and enough work space.
7. Check condition of cutter blocks and tightness of cutter block bolts. - CHECK FOR
CRACKS OR DAMAGE, LOOSEN BOLTS
8. Before using, always check that the two bolts on each cutter block are properly
tightened. Using a loose block will result in damage to block and housing. Also check
condition of cutter blocks. If either cutting edge is dull or chipped, remove retaining
bolts and rotate both blocks so that two new edges come into use. Replace and tighten
bolts. (Each block has four cutting edges.) When all four cutting edges have been used
or if either block is cracked or otherwise damaged, replace both blocks. CAUTION:
A loose or cracked block may result in injury to operator.
8