vigo EPK4570E10 Bedienungsanleitung Seite 14

Use Of Heater With Fixed Legs (Optional)
The fixed leg assembly on which the heater will be placed has to be erected prior to use of
Vigo freestanding electric panel convector heater. The hanger hooks (1) are placed to the
front side of the legs (2) in a way that the spring parts thereof are at the top. Meanwhile
support parts (3) should be placed on the back side of the legs with screws and nuts through
the holes (4).
While determining the location of the electric panel convector heater, the length of the cable
from the heater to the outlet must be calculated carefully in order that the cable does not
tense and wear out unnecessarily. The legs will be placed on the floor where the device will
be located in a way that they form a straight line and the centers of the holes thereon will be
marked with a pen. Holes at a depth of 4-5 cm will be drilled on the marked points with drill
bit Ø9 mm. The included plastic wall plug (6) will be driven into these holes and the legs will
be fixed to the ground with screws and washers.
A sizes;
500 watt electric panel convector heaters: 185 mm (18.5 cm)
1000-1500 watt electric panel convector heaters: 305 mm (30.5 cm)
2000-2500 watt electric panel convector heaters: 505 mm (50.5 cm)
The lower part of the device will be placed on the plastic parts (7) that are on the legs fixed
to the ground. The heater will be laid back in the direction of the arrow (8) Spring hooks
(9) will be placed in the heater holes (10) by pulling them upwards. In this way, assembly is
completed. You can activate your product by electrical connection to the mains plug.
10
8
Figure B
12
9
7
A Sizes
Model A
EPK4550 185 mm (18.5 cm)
EPK4570 305 mm (30.5 cm)
EPK4590 505 mm (50.5 cm)
Figure C