Edirol UA-3 Bedienungsanleitung Seite 15

9. Disconnect the USB cable from your computer, and restart Windows.
Basic operation of the D-Out Smoother
What is the D-Out Smoother?
When audio is played back to a digital device such as MD or DAT connected to the digital output of the UA-3, a certain
amount of time is required for the audio output to be locked immediately after audio playback, so that there may be no
sound for one or two seconds, or the pitch or tempo may become incorrect. The D-Out Smoother is software that allows
the audio to be played smoothly in such situations.
Installing the D-Out Smoother
1. Insert the AUDIO Capture CD-ROM into your CD-ROM drive.
2. Click the Windows [Start] button, and select [Run...].
3. In the Open: text box, input "E:\UA_Util\Setup.exe" and click [OK]. Alternatively, click [Browse], select the
file [Setup(.exe)] located in the UA_Util folder of the CD-ROM drive, and click [Open].
4. The installer will start up, and the Choose Setup Language dialog box will appear. Specify whether you are
using the "English (United States)" or "Japanese" version of Windows, and click [OK].
5. Perform the remainder of the installation as directed by the instructions that appear on-screen.
6. When installation is completed, the Setup Complete dialog box will appear. Click [Finish].
This completes installation of the D-Out Smoother.
Starting the D-Out Smoother
1. Connect the UA-3 to the USB connector of your computer.
2. Click the Windows [Start] button, and in the [Programs] menu, click [D-Out Smoother].
3. The D-Out Smoother will start up.
In some cases it may display"Cannot find USB Audio Device. Check USB cable or select USB
Audio Device again." when starting. If this occurs, the computer has not correctly detected the UA 3. It
is possible that the UA-3 is not connected correctly, or that the driver has not been installed correctly.
Refer to Connections and driver installation (Windows) (p. 8) and check these points.
Using the D-Out Smoother
The D-Out Smoother has an "ON/OFF" switch and a "TEST" button.
"ON/OFF" switch
Normally, you will leave this "ON" when using the digital output of the UA-3.
Turn this "OFF" when connecting or disconnecting the UA-3.
"TEST" button
Click the [TEST] button. If the test audio is heard, the D-Out Smoother is operating for that device.
When using two or more USB Audio Devices such as the UA-3 or MA-150U, use this button to select the UA-3
for which the D-Out Smoother will operate.
Use the following procedure to make your selection.
UA-3
If a dialog box suggesting that you restart Windows appears at this point, follow the sugges-
tion and restart your computer.
In this explanation we are assuming that your CD-ROM drive is drive E:, but the drive name
may be different depending on your computer. If the drive name is different on your com-
puter, input the appropriate drive name. You can check the drive name of your CD-ROM
drive by double-clicking the My Computer icon.
The Setting dialog box will appear at the first time when you start up. Make sure that the
Wave-Out Device shows "USB Audio Device," and click [OK]. If two or more USB audio
devices are displayed, refer to Using the D-Out Smoother (p. 15), and specify the correct device.
Connections and driver installation (Windows)
15