Edirol UA-3 Bedienungsanleitung Seite 113

Recording guitar sounds
When recording guitar sounds with a sequencer or similar device, only the guitar sounds are recorded as you play the
guitar along with the sounds of the computer's audio data.
Make connections as shown in the following diagram.
The guitar input and
audio data on the computer
will be mixed and output.
Set to "INPUT + GUITAR/MIC"
Set the recording sample rate of your recording application to the desired setting. (The available sample rates will de-
pend on your application. For details refer to the owner's manual for your application.) Available sampling frequencies
vary depending on the operating system used.
Use the Guitar/Mic input adjustment slider to adjust the input level. If the LED above the slider lights red, use
the slider to lower the input level. You
high as you can get it before causing the LED to light.
UA-3
Monitor
speakers
LINE IN
Audio cable
LINE
OUT
UA-3
Guitar
will be able to record with higher audio quality if you use the slider to adjust the level so it is as
Computer
USB
port
Only GUITAR will be
recorded to the computer.
USB cable
audio data
on the computer
USB
port
Stereo
Headphones
The guitar input and
audio data on the computer
will be mixed and output.
Signal flow of audio data
on the computer
GUITAR signal flow
Appendices
• The signal input from the Guitar
input jack is not directly output to
the Digital output connector.
• If you change the position of the
Recording input select switch,
you should turn down the volume of
any monitor speaker system that is
connected.
113