Melitta Caffeo Varianza CS Bedienungsanleitung Seite 101

Problem
When foaming milk,
there is not enough
milk foam.
Although the bean
container is full, the
appliance indicates
that coffee beans must
be filled.
Loud grinder noise.
With the My Bean
Select® function, the
display goes off when
the measuring spoon is
put back on.
Brewing unit cannot be
inserted after remov-
ing.
Rapid alternate flash-
ing of the displays:
Rapid alternate flash-
ing of the displays:
The display lights up
without having been
activated:
Cause
Selector switch is not in
the correct position.
Cappuccinatore is
soiled.
Coffee beans do not
drop into the grinder.
Foreign objects in the
grinder.
There are less than 8 g
of coffee beans in the
bean chute.
Handle for the locking
mechanism of the
brewing unit is not in
the correct position.
Drive is not in the cor-
rect position.
Software problem.
Brewing unit is not
inserted.
Appliance is not fully
vented.
Problems
Action
Turn the selector switch to
ƒ
the correct position (see sec-
tion 6.6 one page 80).
Clean the Cappuccinatore (see
ƒ
section 8.3 one page 90).
Press a direct key.
ƒ
Tap lightly on the bean con-
ƒ
tainer.
Clean the bean container.
ƒ
Coffee beans are too oily. Use
ƒ
different coffee beans.
ƒ Contact the hotline.
Top up coffee beans (see sec-
ƒ
tion 5.1 one page 75).
Check that the handle for the
ƒ
locking mechanism is correctly
engaged (see section 8.2 one
page 88).
Press and hold the "Coffee
ƒ
strength" button. Also press
the ON/OFF button. The
appliance initialises. Release
buttons again.
Switch the appliance off and
ƒ
on again (see chapter 4.1 one
page 68).
Contact the hotline.
ƒ
Insert brewing unit.
ƒ
Vent the appliance, turn the
ƒ
rotary regulator clockwise to
the stop for this. As soon as
water flows out of the Cap-
puccinatore, turn the rotary
regulator anti-clockwise to
the stop.
Clean the brewing unit (see
ƒ
section 8.2 one page 88).
101