Adjustment Of Mechanical Stops; Electrical Connections - Entre Matic Ditec PWR25H Bedienungsanleitung

6.5 Adjustment of mechanical stops

Open the wing to its maximum open or closed position, loosen the mechanical stops with a 4 mm
Allen key enough to slide them along the toothed guide, bring them against the mounting pin and
fasten them again.
4 mm
4 mm

6.6. Electrical connections

The PWR25H and PWR35H gear-motors can be connected to control panels LCU30 and LCU40.
To connect the automation to the control panel, proceed as follows:
• Remove the rear cover [9] as shown in paragraph 6.4;
• Fit the cable gland on the automation, securing it with the nut inserted in the hole in the casting
(Fig. 6.1 and 6.2), then insert the connecting cables (Fig. 6.3);
• Connect the various wires as shown in the wiring diagram in Fig. 6.4;
• Secure the rear cover [9] to the gearmotor.
The electrical wiring and start-up of the gear-motors PWR25H and PWR35H are shown in the
installation manuals of control panels LCU30 and LCU40.
A flexible corrugated Ø16 pipe and related Ø20 fitting (not supplied) can be used to increase pro-
tection of the motor cable.
Fig. 6.3
Fig. 6.1 Fig. 6.2
34