Bracket Fastening - Entre Matic Ditec PWR25H Bedienungsanleitung

6.2 Bracket fastening

After choosing the most suitable fastening point for the front bracket [14] to the gate wing, to de-
termine the height position, proceed with the sizing, positioning and fixing of the rear bracket [13].
If necessary, shorten the rear bracket [13] following measurement (S) in Tab. 6.1.
- Once you have fastened the rear bracket [13] following the measurements indicated on page
10, fasten the front bracket [14] to the gate.
- With the gate completely closed, position the front bracket [14], in accordance with meas-
urement (L). Check that the front bracket [13] and rear bracket [14] are properly levelled as
shown in the following figures and fasten the front bracket [13] to the gate.
NB: If necessary, the front bracket [14] can be rotated and fixed as shown in figures [B], in this
way the operator position will be higher by about 40 mm.
i
Configuration [A] is the one recommended for a greater mechanical resistance.
PWR25H
3xØ9
70
155
110 (S)
140 (S)
70
112
90
Ø17,2
80 (S)
2xØ9
13
43
13
87
31
A
14
B
14