Nowsonic AUTARK OD09 Bedienungsanleitung Seite 9

www.nowsonic.com
8.
ANTENNA
The integrated antenna is connected to the internal
of Autark . Wireless operation is set up via the menu (see from
OD09
page 7).
9. socket
DMX OUT
Via this connector you can feed the
a following Autark unit: the source can either be the internal program
mode or a DMX control signal that is input via the
wirelessly via the internal
W-DMX
mode is the source, the Autark unit must be configured as the Master
(via the menu). Otherwise you must select the slave mode.
NOTE: Please note that the last unit in a daisy chained configura-
tion via or in Master/Slave mode should be terminated by a
DMX
termination resistor. Otherwise control problems may arise.
Operation
You can operate Autark
OD09
mode or wired and remotely controlled respectively via
alone mode, the sound sensing is automatically activated and toggles
the 10 internal programs depending on the detected music signal.
W-DMX
DMX signal of the Autark OD09
DMX IN
socket or
receiver. When the internal program
either in Stand-alone or Master/ Slave
DMX . In Stand-
Wiring for Master/Slave mode
receiver In Master/Slave mode, multiple Autark units can be linked whereat the
first unit serves as the master and all following units work as slaves. The
slave units receive their control messages from the master.
Proceed as follows:
1)
Connect a
XLR
to the rear panel of the master unit.
2)
Connect the other (male) plug of the cable to the
socket of the first slave device.
3)
Connect additional slave units according to this pattern (Slave
to Slave
DMX OUT
NOTE:
Please note that the last unit in a daisy chained configura-
tion in Master/Slave mode should be terminated by a termination
resistor. Otherwise control problems may arise.
Next, you must set the devices to Master/Slave mode via their menus.
The operation in the menu is described from page 7.
Wiring in mode
DMX
In combination with a
multiple Autark units in
via , proceed as follows:
DMX
1)
Connect a standard high quality
to the out socket of the controller.
DMX
9
Nowsonic Autark OD09
User manual
cable (not supplied) to the DMX OUT
DMX IN
).
-capable controller, you can control one or
DMX
DMX mode via 1, 4, or 8 channels. For control
audio cable (not supplied)
XLR
GB
socket on
DMX IN