Nowsonic AUTARK OD09 Bedienungsanleitung Seite 8

Nowsonic Autark OD09
GB
User manual
NOTE: When you tap one of the touch sensitive buttons, the
lights of Autark 09 are immediately dimmed in order to protect
OD
your eyes and to enhance visibility. When the operation is finished,
the s reach full brightness after a few seconds.
LED
4.
SWITCH
This switch toggles Autark
OD09
Autark will only be charged when the unit is switched on.
OD09
In order to operate Autark
OD09
on the unit with this switch without connecting the supplied power
cable to the mains supply. The charging capacity of the battery is
displayed on the battery charging indicator (2).
5. Power connector
The supplied mains adapter is plugged to this connector. Use only
CEE
the supplied mains cable. If it gets lost, please contact the dealer from
whom you have purchased your Autark unit.
6. socket
DMX IN
This connector allows to feed an external
Autark can be controlled from an external
OD09
another Autark unit. In both cases, the Autark unit must be configured
as a slave device via the menu.
7.
VALVE
This valve permanently vents the housing of the Autark
no heat accumulation occurs.
NOTE:
Please make sure that the valve isn't blocked or covered, so
that an appropriate ventilation is guaranteed.
8
www.nowsonic.com
on and off. The internal battery of
with the internal battery pack, turn
signal to Autark
DMX OD09
controller or
DMX
, so that
OD09
.