Nowsonic AUTARK OD09 Bedienungsanleitung Seite 10

Nowsonic Autark OD09
GB
User manual
NOTE: A suitable
XLR
to 2 and 3, while ground is soldered to
PIN
that the wiring doesn't change within the cables: a polarity error
or short circuit between the Pins will at least impair or completely
stop the control functionality.
2)
Connect the other (male) plug of the cable to the
connector of the first Autark unit.
3)
Connect additional Autark units according to this pattern (Slave
to Slave
DMX OUT
NOTE: Please note that the last unit in a daisy chained configu-
ration via should be terminated by a termination resistor.
DMX
Otherwise control problems may arise.
Next, you must enter an individual
via its menu. The operation in the menu is described from page 7.
Wireless control via
W-DMX
Autark OD09 incorporates a
implement control signals from a suitable
remote control via W-DMX
1)
Connect a audio cable (not supplied) to the
XLR
of the controller.
audio cable connects the two signal leads
1. Please make sure
PIN
DMX IN
DMX IN ).
address for each Autark unit
DMX
W-DMX receiver that can receive and
transmitter. For
W-DMX
, proceed as follows:
DMX
2)
Connect the other (male) plug of the cable to the
of an optional
3) Turn on the internal
choosing
ON
4)
Next, set the
Addr menu.
5) Finally, press the button at the external
establishing and setting up the connection.
6) The connection is established, when the dot in the lower right of
the display of the Autark unit flashes.
Operation with battery
Autark integrates a battery pack which is automatically charged
OD09
when the unit is connected to the mains and turned on. Using the
internal battery, the unit can be operated up to 12 hours with two or
three colors. However, the power of the
to 5 watts. To operate Autark
plug before powering the unit: after powering up, the current char-
ging status of the battery pack is shown via the
indicator.
In case of a malfunction, you can access and exchange the internal
battery pack via service cover on the back panel. Please contact first
out socket the dealer from whom you have purchased the device.
10
transmitter (e. g. Nowsonic
W-DMX
receiver of the Autark unit by
W-DMX
and finally in the U-D menu.
FUN
DMX address of the Autark unit to A001 via the
W-DMX
s is automatically limited
LED
with the battery, just pull the mains
OD09
www.nowsonic.com
In socket
DMX
-1).
WRX
transmitter for
s of the battery
LED