Max Pro MPBTS254L Bedienungsanleitung Seite 6

required position.
37. Never use thinners to clean the machine. Only use a damp cloth for cleaning.
38. Do not use saw blades which are damaged or deformed.
39. Replace table insert when worn.
40. Use only saw blades recommended by the manufacturer.
41. Take care that the selection of the saw blade depends on the material to be cut.
42. Connect circular saws to a dust-collecting device when sawing.
43. Use and correct adjustment of the riving knife.
44. Use and correct adjustment of the upper saw blade quard.
45. Take care when slotting.
Before use, remove the transport protection:
1)Disassemble the bottom plate by loosening the 4 screws.
2)Remove the transport protection below motor.
3)The handles for height and mitre setting of the saw blade are located in the transport protection inside
the machine.
4)Reassemble the bottom plate.
Switch off the machine immediately when you discover:
1)A defective mains plug or mains lead;
2)A defective switch.
3)Overheating of the machine.
4)Smoke or odeur caused by scorched insulation.
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new ones. It is dangerous to
insert the plug of a loose cable in the wall outlet.
Using extension cables
1)As a supply for this machine always use an unloaded line and/or an extension cable with conductors of at
least 1,5 mm² and protected with a 16 A fuse. Be sure that this extension cable is not longer than 20
metres.
2)Only connect your machine and/or extension cable to an earthed electricity mains.
3)This machine can be switched to the single phase network (220-240V~ 50/60 Hz). If you are in doubt
about the earth of the electricity provisions, consult an electrician first.
ADDITIONAL SAFETY INSTRUCTIONS FOR LASERS
Warning! The laser beam potentially causes severe eye damage. Never look or stare directly into the laser
beam.
During use, do not point the laser beam at people, directly or indirectly through reflecting surfaces.
This laser complies with class 2 according to EN 60825-1/A11, 1996. The unit includes no servicing
components. Do not open the housing for any reason. If the unit is damaged, have the damage repaired by
an authorized repair agent.
Table Saw MPBTS254L User Manual
SYMBOLS
Read the manual
Warning
Wear eye protection
Wear ear protection
Wear dust mask
Do not dispose of old appliances in the household garbage
Keep your hands and feet away from all opening
GB 6