Operation - Max Pro MPBTS254L Bedienungsanleitung

Table Saw MPBTS254L User Manual
2)Place the push stick in the brackets.
Assembly and attachment of the rip fence Fig. D
1)Attach the aluminium fence (A) to the positioning block (B).
2)Now you can attach the complete rip fence to the bench top.
3)Slide the rip fence via one end of the positioning rail (C) over the bench top.
4)Adjust the position of the aluminium fence profile (A) such that the end corresponds to the rear edge of
the saw.
Assembly of the riving knife and the protective cap Fig. E
1)Turn the saw blade completely upwards.
2)Remove the bench inlay.
3)Assemble the riving knife on the set-up for this purpose and use hereby the Allen screws and the filling
rings. Ensure that the riving knife falls properly into the opening (= groove).
4)Now put the inlay back in the bench and fasten it.
5)Now assembly the protective cap onto the riving knife and use hereby the profiled nut and self-locking
nut.
Now lay a lath against the saw blade and the riving knife and check whether it falls properly into the
extension of the saw blade. If this is not the case:Loosen the fastening bolts and place or remove the
filling rings.
1)Above the saw table the radial distance between the riving knife and the toothed rim of the saw blade
shall not at any point exceed 5 mm at the depth of cut set.
2)The tip of the riving knife shall not be lower than 5 mm from the tooth peak, as shown.
Assembly of the saw blade
First remove the plug from the mains before the saw blade is assembled or replaced.
1)Remove the inlay from the bench. Use a screwdriver for this purpose.
2)Turn the saw axle completely upwards. Remove the nut and the outside flange from the saw axle.
3)Now slide the saw blade over the saw axle and now put the outside flange and the nut back. Tighten the
nut by hand.
4)Now use the 2 keys: one for the flange and one for the nut and now clamp it.
5)Now put the inlay back in the bench and fasten it.
Mounting the push stick holders
Mount both push stick holders on the side of the machine using the bolts and rings supplied.
Use of the mitring set-up Fig. A
By turning the handle at the side of the machine you can adjust the saw blade to a maximum of 45° (4).

OPERATION

There are two types of sawing methods:
1.Lengthwise sawing : Sawing the workpiece in the length of the wood grain.
2.Cross-cutting or cutting off : Sawing off the workpiece crosswise.
3. If it concerns a panel, we do not usually distinguish between the wood grain, but we name the method
where we saw off a part of the width of the panel (lengthwise sawing) and when we cut off the length
(cross-cutting or cutting-off).
For both sawing methods one of the fences must be used. Therefor never saw without a fence!
Attention! Before you start sawing, first check the following:
1. Is the saw blade secured?
2. Are all the locking handles secured?
3. Is the fence parallel to the saw blade?
4. Is the protective cap working properly?
5. Are you wearing safety goggles?
6. Is the saw blade not rubbing against anything?
It is absolutely necessary to take these points into consideration before you start work!
Lengthwise sawing
11 GB