Technical Information - AEG LAVATHERM 65280AC Benutzerinformation

The door
does not
close.
Err (Error)
on the dis-
play.
Abnormally
elapsing
time on the
display.
Programme
inactive.
Drying cycle
too short.
Drying cycle
too long
1) If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on.
Make a selection of the new programme. Push the Start/Pause button. Does not operate? -
contact the service centre and give the error code.
2) follow the programme description — see PROGRAMMES chapter
3) see CARE AND CLEANING chapter
4) see section WATER HARDNESS in HINTS AND TIPS chapter
5) Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle
complete section).

TECHNICAL INFORMATION

height x width x depth
drum volume
Too high water hardness.
The filter not locked in the posi-
tion.
The laundry is locked between
the door and the seal.
You try to change the pro-
gramme or the function after
the start of the cycle.
The function you try to activate
is not applicable with the selec-
ted programme.
The time to end is calculated on
the basis of the volume and
dampness of the laundry.
The water container is full.
To small laundry volume.
The laundry is too much dried.
The filter is clogged.
Too high volume of the load.
The laundry not spun sufficient-
5)
ly.
Very high room temperature -
this is not the appliance mal-
function.
Set applicable water hardness
Put the filter in the correct posi-
tion.
Put the load correctly in the
drum.
Turn the tumble dryer off and
on. Make the new selection.
Turn the tumble dryer off and
on. Make the new selection.
The automatic procedure — this
is not the appliance malfunction.
Drain the water container
push the Start/Pause button.
Do the selection of time pro-
gramme.
Do the selection of time pro-
gramme or higher drying level
(e.g. Extra Dry )
Clean the filter.
Obey the maximum load vol-
ume.
Spin correctly the laundry.
If possible, lower the room tem-
perature.
850 x 600 x 600 mm (maximal 640 mm)
118 l
ENGLISH 87
4)
.
3)
,