Child Lock Function - AEG LAVATHERM 65280AC Benutzerinformation

THE BUZZER (ZOEMER)
FUNCTION
When the buzzer function is activated
you can hear the buzzer at the:
• cycle end
• anti-crease phase start and end
• cycle interruption
The buzzer function is by default always
on. You can use this function to activate
or deactivate the sound.
THE ANTICREASE (ANTI-
KREUK) FUNCTION
Extend anti-crease phase (30 minutes)
at the end of the drying cycle to 90 mi-
nutes. This function prevents laundry
from creases. Laundry can be removed
during the anti-crease phase.
THE DELAY START
(STARTUITSTEL) FUNCTION
Let to delay the start of a drying
programme from minimum of
30 minutes to maximum of 20
hours.
1. Set the drying programme and
functions.
2. Push the Delay Start (Startuitstel)
button again and again until the
necessary time of the delay come
into the view on the display (e.g.
if the programme has to start af-
ter 12 hours.)
3. To activate the Delay Start (Startuit-
stel) function, push the Start/Pause
(Start/Pauze) button. The time to
start decreases on the display.
STARTING A PROGRAMME
To activate the programme push the
Start/Pause (Start/Pauze) button. The
LED above the push button changes
the color to red.
CHANGE A PROGRAMME
To change a programme, turn the pro-
gramme selector to Stop and then set
the programme again.

CHILD LOCK FUNCTION

The child lock can be set to prevent the
children to play with the appliance. The
child lock function locks all push but-
tons and the programme dial (this func-
tion does not lock On/Off (Aan/Uit) but-
ton). To activate the child lock function
push the Delay Start (Startuitstel) and
Anticrease (Anti-kreuk) buttons at the
same time until the symbol
to view on the display. To deactivate
push again the above buttons until the
symbol go out of view.
You can activate the child lock function:
• before you push the Start/Pause
(Start/Pauze) button - the appliance
cannot start
• after you push the Start/Pause (Start/
Pauze) button - all the push buttons
and the programme dial are deacti-
vated
AT THE END OF PROGRAMME
When the drying cycle is completed,
the symbol flashes on the display. If
the Buzzer (Zoemer) function is on, an
acoustic signal sounds intermittently for
one minute.
To remove the laundry:
1. Push the On/Off (Aan/Uit) button
for 2 seconds to deactivate the ap-
pliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
After each drying cycle:
• clean the filter
ENGLISH 79
come in-